Volvo Penta TMD22 Wartungshandbuch PDF herunterladen (Seite 102)

100

Cooling system

Sea water pump, replacement

(20A-06)

Applies to MD22A, MD22L-A, TMD22A

NOTE! If the installation plate and adapter plate for

the sea water pump are removed, they must be

aligned (using alignment tool 885038) before the

pump is installed, see operation 20A-08.

Drain the sea water circuit, operation 20A-03.

Detach the hose clamp at the pump.

Remove the four mounting screws which hold the

pump against the adapter plate and remove the

pump.

Clean the mating surfaces on the pump housing and

adapter plate.

Clean the pump drive components and check them

for wear. Replace worn components if necessary.

If the flange has been removed from the camshaft,

tighten the flange screws to 9 Nm.

Apply grease with a high melting point (eg Shell Al-

vania R2) on the drive components and fill the in-

side of the drive housing.

Align the cut out in the pump shaft (A1) with the

flange driving pin (A2). Install the pump on the en-

gine with a new gasket between the pump and the

adapter plate. Install the mounting screws and tight-

en to 9 Nm.

Connect the hose connectors to the pump.

Open the seacock if necessary.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 131 132

Keine Kommentare

Volvo Penta TMD22 Wartungshandbuch Seite 102